Bend-All 80

Enlarge

There are no alternate images available for this product.

Bend-All 80

BEND-ALL 80 is a heavy duty water soluble paste developed as a lubricant for drawn over mandrel tube and pipe bending. It forms a strong barrier film with a high degree of lubricity and extreme pressure protection between the tube and the mandrel. BEND-ALL 80 uses a solid film lubricant to reduce the coefficient of friction and improve lubricant film strength. It is safe for use on all metals. BEND-ALL 80 was developed for use on the most difficult bending operations. It can replace straight chlorinated paraffin honey oils, and home brews of two or three products on tough 1 D bends. BEND-ALL 80 has been very successful on 409 SS large diameter truck and tractor exhaust tubing. It has also been very successful at dilutions with water up to 3:1 in deep drawing stainless steel.

Gel/Paste

Usage

BEND-ALL 80 is typically used neat for draw bending and end forming operations. It can be hand applied by brush or swab, or pumped through the mandrel. It will not harden in the mandrel or in the drum. BEND-ALL 80 can be pumped directly out of the drum and does not require a follower plate in the drum. BEND-ALL 80 can be removed by aqueous wash using a high quality neutral pH cleaner, such as TOWERKLENE SAF-T-22 (for immersion), or TOWERKLENE SAF-T-24 (for spray wash) operating at 140-160º F. Normally BEND-ALL 80 is best if used within six months of the manufacture date. Keep the product containers sealed when not in use.

Benefits

Contains No Hazardous Ingredients
Improves Tool Life
Will Not Slump Off Mandrel Under Heat
Use On Large Diameter Tubing
Use For The Most Difficult Bending Operations & Does Not Harden Like Pigmented Lubricants
Is Operator Friendly

Documents

Product Technical Data Sheets

80 BEND-ALL

SDS sheets

80 Bend-All SDS

Phone: 773.927.6161